Table centrifuge maintenance and maintenance:

Before operation, the power supply should be cut off and the centrifuge brake should be loosened first. You can try to turn the drum by hand to see whether there is a bad bite.
Check other parts for loosening and abnormal conditions.
Turn on the power and start the car in a clockwise direction (usually about 40-60 seconds from static state to normal operation).
Usually each equipment to the factory must be empty running for about 3 hours, no abnormal conditions can work.
Materials should be placed as evenly as possible.
It must be operated by special personnel and the capacity must not exceed the quantity.
It is strictly prohibited to overspeed the machine, so as not to affect the service life of the machine.
After the machine is started, if there is any abnormal situation, it must be stopped for inspection. If necessary, it must be disassembled, washed and repaired

Table centrifuge operates at high speed, so you must not touch its drum with your body in case of accidents.
The mesh number of press cloth should be determined according to the size of solid particles of the separated material, otherwise the separation effect will be affected. In addition, the press cloth should be installed
The sealing ring is embedded in the drum sealing groove to prevent materials from running in.
To ensure the normal operation of the centrifuge, please refuel and maintain the rotating parts every 6 months. At the same time check the running lubrication of the bearing, there is no wear phenomenon; Whether the parts in the brake device wear, serious replacement; Bearing cover has no oil leakage.
After the machine is used, it should be cleaned and kept clean.
Do not separate non-anticorrosive centrifuge from highly corrosive materials; In addition, in strict accordance with the equipment requirements, regulations of operation, non-explosion-proof centrifuge must not be used for flammable, explosive occasions.
please contact Whatsapp & Wechat : +86 180 8048 1709